3D Or Bust

Many of you know about and have flown the 71" wing span  Extra Extra . Since the initial plane was developed on my CNC foam cutter it was not as good a candidate for others to build especially if they didn't vacuum bag. Thus the EE V2 was born. It's a hybrid fuse that has dual tubes and is 1lb lighter than the foam prototype. This is one stiff fuse with very very little twist!

The plane as shown 144.9oz (9.05625lbs, 4.9 wing cube loading). This includes the fuse, wings, linkage, servos (1 HS 85 throttle servo, 4 170oz MG servos, 2.0oz per), APC 18-6W prop, Saito 180 with older heavy muffler (~33oz) , 20oz Dubro fuel tank, CF Troy built wing tube, two 1/2" 55" epoxy/GF tubes (Swany's), 7.3 oz 2700 mah NIMH 6V battery (heavy I know, LION pack in the other plane is 3oz), aluminum gear , tail wheel and gear (didn't weigh it separately), Hitec Supreme 8 channel receiver, and all HD servo extensions. Also, a plane has been built in the super light category using an OS 120AX. It came out at ~7lbs 11oz (1383 sq. in, 4.1 wing cube loading). Nose to tail it is 66.5" long.

Current inside rail spacing/clearance is 44mm (1.73") and is sized for a Saito 125-180, YS 110-160, Roto 25 or Evo 26cc gas, Syssa 30cc, or equivalent. It can be opened up from there as the inside clearance to the tubes (mounts are tied/glued into the tubes) is 82.1mm (3.23") .

The "short" kit includes ~95% of the wood you need as the kit is nearly all CNC cut parts.  The kit also includes man parts you would have to make by hand (dowels, ply mount reinforcements, etc,) as well as Aluminum main landing gear.  You will need to order an aluminum or the preferred CF wing tube/socket as well as two 1/2" epoxy-glass fuse tubes.  The sources and part numbers are listed on the prints that come with the kit.

The EEV2, while being a large plane, can fly like a "kitten" or roar like a 3D monster of a LION

When you need something extra try an EXTRA EXTRA!

Requires 4 hs5645MG servos (or equivelant) for the ailerons and tail surfaces and, if glow/gas, one hs-85MG, hs-225MF, or any standard size metal gear servo for throttle. 

The kit includes AL landing gear and 95% of the wood/ply CNC cut parts necessary for completion.

Motor/engine, servos, hardware (other than landing gear), wing tube, etc. is not included.   Details of what else is needed can be found here:

http://i1020.photobucket.com/albums/af321/hazzbro/EEBOM.jpg

Made proudly in the USA!